Provisioning Your Isdn Line; Ordering U.s. And Canadian Isdn Bri Services - 3Com NETBuilder SI Using Manual

E
Ordering U.S. and
Canadian ISDN BRI
Services
P
ROVISIONING
This appendix provides U.S., Canadian, German, and Dutch provisioning
information for the built-in ISDN port on model 43x, 53x, 44x and 54x
SuperStack II NETBuilder SI bridge/routers.
To order ISDN service from your telephone company, follow these steps:
1 Call the telephone company and ask for the ISDN representative.
2 Tell the representative you want ISDN service for a SuperStack II
NETBuilder SI bridge/router, and that you have the following information:
Line provisioning
ISDN outlet type
3 Tell the representative that the Bellcore ISDN ordering code (IOC) is
"Capability R." The IOC tells the telephone company which parameter
settings to use for SuperStack II bridge/routers.
Not all Regional Bell Operating Companies use IOCs.
4 If you have a model 43x or model 53x bridge/router with an ISDN S/T
connector, ask for an NT1 to connect your SuperStack II bridge/router to
the ISDN line. (You can also purchase an NT1 from a reseller.)
5 Ask for the following information to fill out the ISDN Information Sheet:
ISDN Switch Type. Ask the representative which ISDN switch type
your line uses. Place a check mark next to that switch on the ISDN
Information Sheet. Each switch type has a corresponding provisioning
information table later in this section.
Number of ISDN Phone Numbers. Your ISDN line can support one
or two phone numbers. Specify how many phone numbers you are
ordering.
Y ISDN L
OUR INE