Installing In A Rack - 3Com NETBuilder SI Using Manual

Installing in a Rack

To install the bridge/router in a rack, follow these steps:
CAUTION: Do not restrict air flow around the sides and back of the
bridge/router.
1 Secure the rack-mount brackets to each side of the chassis using two
flathead screws per bracket.
2 Hold the chassis between the poles of the rack and attach the brackets to
the rack using panhead screws (you must provide these screws). Tighten
each screw securely.
CAUTION: Using fewer than two screws to secure the brackets to the
rack may cause the boundary router to fall and sustain damage not
covered by the warranty.
Mounting the Bridge/Router 33