Troubleshooting; Using The Monitor Utility; Boot - 3Com NETBuilder SI Using Manual

A
Using the Monitor
Utility

Boot

Syntax
Description
T
ROUBLESHOOTING
This chapter contains the following sections:

Using the Monitor Utility

Normal LED Meanings
Error LED Meanings
Performing Loopback Tests
Performing a Memory Dump
If your bridge/router is unable to boot from the software, you can attach
a console to the console port and access the firmware monitor utility.
To access the monitor utility from the software, enter:
MONitor
CAUTION: The monitor utility stops the software from running, and you
must reset the bridge/router to exit the firmware.
The following commands are available from the monitor utility:
BT [<filename> [<config directory>]]
The BT command allows you to reboot or to override the default boot
path configured in the firmware by the monitor or by the SysconF
command in the software. If you enter a new boot path, the firmware
parameter is updated to reflect the new path.
If you do not enter a filename or a configuration file directory, the system
attempts to boot from boot.68k in the /primary directory. If there is an