Installing The Hardware; Required Equipment - 3Com NETBuilder SI Using Manual

3
Required
Equipment
Table 6 Equipment Received and Equipment Needed
Shipping carton contents
What you need to provide
* The software is preinstalled in the flash memory drive of the bridge/router and automatically loads when you turn on the power.
The software CD-ROM is for software recovery purposes only.
I
NSTALLING THE
This chapter describes how to install your SuperStack II NETBuilder SI
bridge/router.
Table 6 lists the items you receive in the shipping carton and items you
need to provide.
SuperStack II NETBuilder SI bridge/router
Power cable
Models 44x and 54x: ISDN U cable
Models 45x, 55x, 46x and 56x: CSU/DSU loopback plug
Rack-mount kit
Models 46x and 56x: RJ-48 T1 cable
Software CD-ROM * (except for boundary router models)
Documentation and documentation CD-ROM
Synchronous serial devices like a channel service unit/digital service unit
(CSU/DSU), modem, or ISDN TA.
NT1 for models 43x and 53x in the U.S. and Canada
Interface module (available from 3Com — optional)
10BASE-T or 100BASE-TX network cables
Flex-WAN cables (available from 3Com). See "Serial Connectors and Flex-WAN
Cables" on page 174 for more information about ordering Flex-WAN cables.
Models 43x and 53x: ISDN S/T cable
Models 45x and 55x: CSU/DSU cable
Terminal, PC, or modem and cable
WARNING: To eliminate cable noise emission in excess of FCC
regulations, part 15, subpart J, and EN55022B, all interconnection cables
should be equipped with shielded connectors, the backshells of which
must completely surround the cable shield.
H
ARDWARE