Chapter 3
Setting Up the Cisco Unified IP Phone
Understanding the Cisco Unified IP Phones 7906G
and 7911G Components
Network and Access Ports
Handset
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager
OL-10008-01
Understanding the Cisco Unified IP Phones 7906G and 7911G Components
The Cisco Unified IP Phones 7906G and 7911G include these components on the
phone or as accessories for the phone:
Network and Access Ports, page 3-5
•
Handset, page 3-5
•
Speaker, page 3-6
•
Headset, page 3-7
•
The following ports are available on the Cisco Unified IP Phones 7906G and
7911G:
Network port—Labeled 10/100 SW. Use the network port to connect the
•
phone to the network. You must use a straight-through cable on this port. The
phone can also obtain inline power from the Cisco Catalyst switch over this
connection. See the
and 7911G" section on page 2-4
Access port (Cisco Unified IP Phone 7911G only)—Labeled 10/100 PC. Use
•
the access port to connect a network device, such as a computer, to the phone.
You must use a straight-through cable on this port.
Each port supports 10/100 Mbps half- or full-duplex connections to external
devices. The speed and connection type are set through auto-negotiation. You can
use either Category 3 or 5 cabling for 10-Mbps connections, but you must use
Category 5 for 100 Mbps connections.
See
Figure 3-3
for the connection ports available on the back of the
Cisco Unified IP Phones 7906G and 7911G.
The handset is designed especially for use with a Cisco Unified IP Phone. It
includes a light strip that indicates incoming calls and voice messages waiting.
"Providing Power to the Cisco Unified IP Phones 7906G
for details.
3-5