Cisco 7906G Administration Manual page 100

Overview of Options Configurable from a Phone
Table 4-1 Network Configuration Menu Settings
Category
DHCP settings
IP settings
TFTP settings
VLAN settings
Port settings
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager
4-6
Description
Dynamic Host Configuration Protocol (DHCP)
automatically assigns IP address to devices
when you connect them to the network.
Cisco Unified IP Phones enable DHCP by
default.
If you do not use DHCP in your network, you
can make IP settings manually.
If you do not use DHCP to direct the phone to
a TFTP server, you must manually assign a
TFTP server. You can also assign an alternative
TFTP server to use instead of the one assigned
by DHCP.
Allow you to change the administrative VLAN
used by the phone.
Allow you to set the speed and duplex of the
network and access ports.
Related Topics
Displaying a Configuration Menu, page 4-2
•
• Unlocking and Locking Options, page 4-3
Editing the Values of an Option Setting, page 4-4
•
Network Configuration Menu, page 4-7
•
Device Configuration Menu, page 4-15
•
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Network Configuration Menu
Option
DHCP Enabled
DHCP Address Released
Domain Name
IP Address
Subnet Mask
Default Router 1-5
DNS Server 1-5
TFTP Server 1
Alternate TFTP
TFTP Server 2
Admin. VLAN ID
PC VLAN (applies to 7911G
only)
SW Port Configuration
PC Port Configuration (applies
to 7911G only)
OL-10008-01