Cisco 7906G Administration Manual page 84

Installing the Cisco Unified IP Phone
Procedure
Connect the footstand to the
1.
back of the phone. See
Figure 3-1 and Figure
Figure 3-1 shows the
Note
Cisco Unified IP Phone
7911G. The procedure
for connecting the
footstand is the same for
the Cisco Unified IP
Phone 7906G.
Connect the handset to the
2.
Handset port.
Connect the power supply
3.
to the Cisco DC Adapter
port (DC48V) .
Connect a Category 3 or 5
4.
straight-through Ethernet
cable from the switch to the
10/100 SW port.
(Cisco Unified IP Phone
5.
7911G only) Connect a
Category 3 or 5
straight-through Ethernet
cable from another network
device, such as a desktop
computer, to the 10/100 PC
port.
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager
3-10
To install a Cisco Unified IP Phone, perform these steps:
Notes
—
3-2.
—
Optional. When connecting
phones powered by an external
power supply, you must connect
the power supply to the phone
before connecting the Ethernet
cable to the phone.
When disconnecting the phone,
you must disconnect the Ethernet
cable before disconnecting the
power supply.
Each Cisco Unified IP Phone
ships with one Ethernet cable in
the box.
Optional. You can connect
another network device later if
you do not connect one now.
Chapter 3 Setting Up the Cisco Unified IP Phone
Reference
—
—
See the "Providing Power to the
Cisco Unified IP Phones 7906G
and 7911G" section on page
See the "Network and Access
Ports" section on page 3-5
guidelines.
See the "Network and Access
Ports" section on page 3-5
guidelines.
2-4.
for
for
OL-10008-01