Control Strip Auto Loading Unit (Positions Of Pcbs And Electrical Parts) - Frontier LP7500 Service Manual

Distributed by: minilablaser.com

Control strip auto loading unit (positions of PCBs and electrical parts)

! ! ! ! Layout diagram
5
(Position of PCBs)
No.
1 Control strip driver PCB
2 Infrared communication unit
(Position of electrical parts)
No.
3 Control strip feed motor
4 Control strip holder detection switch
5 Status lamp
! ! ! ! (Checking of the status lamp)
When the auto loading unit is inserted, the green and red lights, as show in the figure, turn on from off.
If the light blinked
If an error occurs, the light blinks for about 60 seconds.
• If the red light blinked
Not communicating normally.
Start over the process following the procedure below.
63315
1
2
3
Name
Name
When inserted
Green: lighting
Red: lighting
63315
Positions of electrical parts (Processor section)
4
Manual No.
66810
66830
Symbol
M1
LM1
LED1
In ten seconds after
Green: lighting Green: not
Red: not lighting lighting
Red: not lighting
G085189
Remarks
Remarks
G088042
1/2