Frontier LP7500 Service Manual page 114

Distributed by: minilablaser.com
11.
Remove the laser control box. (four screws)
I
MPORTANT
• Remove the laser control box. Turn it over and place on the processor top cover.
Take care for the wiring connected to the laser control PCB and perform the operation.
• Do not lose the four vibration-proof rubbers of the laser control box.
12.
Remove three vibration-proof mounts and a vibration-proof angle bracket. (two screws)
I
MPORTANT
• This step is required only when you replace the laser unit with new one.
26710
Laser control box
Vibration-proof rubber
26710
Laser unit
G085238
Vibration-proof rubber
Vibration-proof rubber
G085239
3/6