Frontier LP7500 Service Manual page 309

Distributed by: minilablaser.com
$ Version (LASER)
You can check the type of the laser unit by checking the version name of LASER.
No. Display
LASER
1 1.089
2 H
3 h
4 B
$ Communication
If the communication status of each control PCB is not normal, the versions of Version (CPU) and BOOT are not
displayed normally.
• Depending on the ARCNET communication feature, Version (CPU) and BOOT on the System Version Check display may not be
able to decide if the ARCNET communication is working or not.
• In that case, the ARCNET communication status can be checked more correctly by using ARCNET Self-Diagnosis.
For details, see 35940.
Enter the System Version Check mode again to update the versions of Version (CPU) and BOOT.
! ! ! ! Profile Data (SP1)
The profile data version is displayed.
1
1.009 X1 HhB1 N
Shows the software version of the laser control PCB.
Shows the G laser driver type.
• H: G laser driver (J391231)
• I: G laser driver (J391160)
Shows the laser unit type.
• h: laser unit (Type HhB)
• i: Laser unit (Type IiB)
• #: Laser codes on the laser operation record PCB (inside the laser unit) are not entered.
Shows that the R-AOM and B-AOM driver functions are installed in the laser unit.
• Example:
B: Laser unit (Type HhB) or Laser unit (Type IiB)
• #: Laser codes on the laser operation record PCB (inside the laser unit) are not entered.
35500
Explanation
4
3
2
B H h B
I i
35500
Maintenance
OK
35700
35700
2/2