Distributed by: minilablaser.com
N
OTE
• A magenta arrow is shown on the Test Print Confirmation print.
Test print
• A piece of paper with the advance length of 216 mm and the margin of 5.0 mm is printed.
• The paper width, 〈A ####(#)〉 is printed as the CVP imprinting.
! ! ! ! White Border Width Correction
I
MPORTANT
• If the margin on the test print is 0.5 mm, the correction is not necessary.
1.
Check that the zigzagging adjustment of the magazine mount has been completed.
22100
2.
Check that the exposure center correction has been completed.
36070
3.
Carry out Test Print of F: Functions.
4.
Measure the right and left margins on the test print.
5.
Enter the measured value in each item.
6.
Carry out Test Print Confirmation of F: Functions and make sure that the margin is 5.0 mm.
36100
Test Print (Confirmation)
G066121
G068472
36100
Printer Mechanical Adjustment
2/2