Frontier LP7500 Service Manual page 603

Distributed by: minilablaser.com
No. 06203
Setup error.
Error message release
YES
Condition
Suffix number
#2001
When measuring the daily setup test print, the density for specific colors between steps did not rise
consecutively.
#2002
The Dmax of the measured daily setup print was 3.8 or more, and the daily setup Dmax data for 15 days were not
ready.
#2003
The Dmax of the measured daily setup print was 3.8 or more, and the daily setup Dmax data for 15 days did not
change consecutively day by day and changed suddenly.
#2004
The Dmax is within the range of 0.9 and 3.8, but when calculating the daily setup correction value, the correction
value for specific colors was over 10 times as high as the previous value.
#2005
When calculating the daily setup correction value, the correction value for specific colors was 3 key or more.
#2006
When calculating the daily setup correction value, the total amount of the correction value (specified color) after
completing the initial setup or paper specification registration setup exceeded the limit value.
Between steps
I
MPORTANT
• It occurs when an abnormal correction value is calculated. Confirm that the color density state of the test print have not
changed too much in comparison with the previous print.
N
OTE
• See the setup print judgment flow at the daily setup.
Diagnosis
The countermeasure action and the failed part would differ depending on the suffix number.
If the test print color density is normal
Suffix
number
#2002
Clean the calibration plate.
#2003
Replace the calibration plate if it is scratched on.
#2004
#2005
#2006
#2001
Colorimeter unit
#2002
Processor control PCB
#2002
#2004
#2005
#2006
46200
Condition
G083195
56620
Countermeasure and failed part
46200
Error message: Printer 3
Error message: Printer 3
Manual No.
−
27460
27460
66200
1/21