Automatic Color Measurement Operation For Setup Prints - Frontier LP7500 Service Manual

Distributed by: minilablaser.com

Automatic color measurement operation for setup prints

This section explains the automatic color measurement operation for setup prints.
N
OTE
• When attention messages or error messages is shown after failed to measure the setup print, the setup print is output without
registering the result.
• When the measurement would be failed and the attention message
shown, you can measure the setup print again if inserting the print to the colorimeter unit manually.
1.
The print was inserted to the colorimeter unit.
Paper sensor 2
Colorimeter
Paper advance motor
2.
Detects the paper leading end by paper sensor 1, and releases the pressure of the measurement position.
• Paper sensor 1: LIGHT to DARK
• Pressure solenoid: ON
If paper sensor 1 does not turn DARK
• No. 05535
Paper has jammed in the processor section.
3.
Starts to advance the paper after detected the paper leading end by paper sensor 1.
• Paper sensor 1: DARK
• Paper advance motor: ON (forward)
If paper sensor 1 turns LIGHT
• No. 01552-00001
The paper in the Colorimeter is too short. It cannot be measured.
56610
No. 01029The measurement failed. Measure it again. is
Remeasurement inlet
Paper sensor 1
Pressure solenoid
Measuring
56610
Colorimeter unit operation
Paper
G085219
1/3