Frontier LP7500 Service Manual page 552

Distributed by: minilablaser.com
No. 05922[F]
Replenisher section door is open.
Error message release
YES
I
MPORTANT
• If the above error message is shown, do not click YES to close it and continue the printing process without performing the
diagnosis below.
After a set number of prints are output,
and then printing cannot be performed.
N
OTE
• If printing process is continued after the above error is shown, the time is counted as Replenishment Lack Time and the P1R, P2RA
and P2RB replenishers will not be replenished.
Condition
When the replenisher section door is opened while the replenisher cartridge is open (replenishment solution is being created).
Suffix number
00001 When the replenisher section door is opened before the cap is cleaned.
00002 When the replenisher section door is opened while the cap is being cleaned.
• For the QSS-3701/3702/3703/LP7500/LP7600, about 507 prints whose size is 127 mm × 89 mm can be processed after the error
whose suffix number is 00001 occurs.
• For the QSS-3704/3705/LP7700/LP7900, about 545 prints whose size is 127 mm × 89 mm can be processed after the error whose
suffix number is 00001 occurs.
• For the suffix number 00002, print proceeds if an error message is cleared by pressing YES.
Countermeasures for the suffix number 00001
1. Close the replenisher section door.
2. Perform recovery procedure 2 from the replenishment error.
4620
Check Point
Check if the replenisher section door is closed securely.
Check the Interlock Switch (Replenisher Section Door) status via Input Check.
Diagnosis
Interlock Switch (Replenisher Section Door)
F replenishment I/O PCB
Processor control PCB
N
OTE
• To access the wiring diagrams, click Wiring diagrams in Bookmarks.
45900
No. 05912[F] Predetermined process amount was exceeded. will be shown,
Condition
Failed part
45900
Error message: F replenishment
Condition
63280
66800
66200
-
35220
Manual No.
14/16