Distributed by: minilablaser.com
Replacing the elevator motor [J]
! ! ! ! Procedure
1.
Remove all the tablet cartridges.
2.
Remove the tablet replenishment unit section cover.
20020
3.
Disconnect the connector(s).
J/P540: Tablet replenishment drive PCB
4.
Remove the motor mounting plate from the frame. (four screws)
5.
Remove the drive gear cover. (two screws)
6.
Remove the gear (12T). (one screw)
Motor mounting plate
7.
Replace the elevator motor. (three screws)
8.
Attach the gear (12T).
Drive gear cover
Gear (12T)
G050734
Elevator motor
G050735
27640
27640
Tablet replenishment section
1/2