Distributed by: minilablaser.com
Print sorter unit operation [print sorter unit (10-inch type)]
This section explains the operation until the print receiving tray starts to move after paper is output to the print sorter unit.
! ! ! ! Basic operation of the print receiving tray
1.
The last piece of paper of an order is output to the print receiving tray of the print sorter unit.
2.
The print receiving tray moves.
• Sorter motor: ON
When the following three conditions are fulfilled, the print receiving tray moves.
• Condition 1: The print sensor detects the paper leading edge of the next order.
• Condition 2: A fixed time has passed after the sensor detects the rear edge of the paper of the previous order.
• Condition 3: The paper guide is in open position (raised). See
(raised).
N
OTE
• If condition 2 is not applied (inadequate interval between customer orders), the print receiving tray will not start
until a specified length of time elapses.
56300-5
Sorter motor: DM4
56300-5
Print sorter unit operation
When the paper guide moves to open position
Sorter home sensor: SE26
G082019
1/4