Scanning Active Time - Datalogic Gryphon I GBT4400 Product Reference Manual

Scanning Active Time

This setting specifies the amount of time that the reader stays in scan ON state once the state is
entered. The range for this setting is from 1 to 255 seconds in 1-second increments.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the result with leading zeroes to yield three digits. For example: 0 = 000, 5 = 005, 20
3. Go to
4. Scan the bar code: SELECT SCANNING ACTIVE TIME SETTING.
5. Scan the appropriate three digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See
Table 40. Scanning Active Time Setting Examples
STEP ACTION
1 Desired Setting
2 Pad leading zero(es)
3
4
Scan Three Characters From
5
Appendix D, Keypad
6
Product Reference Guide
= 020, etc.
page 101 and scan the ENTER/EXIT PROGRAMMING MODE bar code to
enter Programming Mode.
the duration which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
Mode.
1 Second
001
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT SCANNING ACTIVE TIME SETTING
'0' , '0' and '1'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix D,
Table 40 for some examples of how to set this feature.
EXAMPLES
90 Sec. (1.5 min.) 180 Sec. (3 min.) 255 Seconds (4.25 min.)
090
'0' , '9' and '0' '1' , '8' and '0'
Scanning Features
Keypad, that represent
180 255
'2' , '5' and '5'
279