Stand Operation - Datalogic Gryphon I GBT4400 Product Reference Manual

Reading Parameters

Stand Operation

Specifies the behavior of the reader when stationary in a stand.
There are two conditions which cause the reader to switch to Stand Mode:
1. The reader is configured to switch to Stand Mode when stationary.
2. The reader is placed into the cradle of the base station.
Below are further options concerning Stand Operation.
Ignore Autorecognition.
Switch to Stand Mode.
placed in the stand.
Switch to Flashing.
in the stand.
Switch to Always On.
placed in the stand
$CSMSD01(
CR)
Change to Stand Mode
$CSMSD03(CR)
Change to Flashing
Product Reference Guide
Disables mode switching when the reader is placed in a stand.
Automatically switches the reader to Stand Mode when the reader is
Automatically switches the reader to Flash Mode when the reader is placed
Automatically switches the reader to Always On mode when the reader is
.
Enter/Exit Programming Mode
$CSMSD00(
CR)
Do Not Change Mode
DEFAULT
$CSMSD02(CR)
Change to Always On
99