Configuration Using Bar Codes; Configuration Parameters - Datalogic Gryphon I GBT4400 Product Reference Manual

This and following sections provide programming bar codes to configure your reader by
changing the default settings. For details about additional methods of programming, see
"Configuration Methods" on page

Configuration Parameters

Once the reader is set up, you can change the default parameters to meet your application needs.
Refer to
default values and select the interface for your application.
The following configuration parameters are divided into logical groups, making it easy to find
the desired function based on its reference group.
Interface Configuration:
•
•
Parameters common to all interface applications:
•
•
Symbology-specific parameters:
•
•
Product Reference Guide

Configuration Using Bar Codes

You must first enable your reader to read bar codes in order to use this
section. If you have not done this, go to
complete the appropriate procedure.
"Standard Defaults" starting on page 301 for initial configuration in order to set the
"RS-232/USB-Com Interfaces" on page 46
"Keyboard Settings" on page 55
"Data Format" on page 75 gives options to control the messages sent to the Host system.
"Reading Parameters" on page 89 control various operating modes and indicators status
functioning.
"1D Symbologies" on page 109 provides configuration of a personalized mix of 1D codes,
code families and their options.
"2D Symbologies" on page 201 provides configuration of a personalized mix of 2D codes,
code families and their options.
You must first enable your reader to read bar codes in order to use this
section. If you have not done this, go to
complete the appropriate procedure.
16.
Chapter 3
Setup, starting on page 17
Setup, starting on page 17
and
and
37