Enter/Exit Programming Mode
Motion Sensitivity
Defines discrete set of levels for scanner motion sensitivity when in handheld use.
$CMOSY01(CR)
Motion Sensitivity = Medium
Motionless Timeout
Specifies the waiting time in 100 millisecond ticks to assume that the reader is in a motionless
condition. The selectable range is 500 msec to 25.5 Seconds. When no motion event is detected
for a period of time longer than this timeout, the software assumes the reader is in a motionless
condition. This normally results in returning the scanner to Stand Mode. This option relates to
such features as Aimer On and Stand Mode Object Sense scanning with respect to motion. See
"Motionless Timeout" on page 288
$CMOTO
Select Motionless Timeout Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again at
the beginning.
DEFAULT
252
$CMOSY00(CR)
$CMOSY02(CR)
in References.
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by three digits from the Alphanumeric
characters in
desired character(s). End by scanning the ENTER/EXIT
bar code again.
020 = Motionless Timeout = 2 seconds
Motion Features
Motion Sensitivity = Low
DEFAULT
Motion Sensitivity = High
Appendix D Keypad
representing your
~
CANCEL
Gryphon™ I GD44XX/GBT4400/GM440X