Aiming Pointer; Aiming Duration Timer - Datalogic Gryphon I GBT4400 Product Reference Manual

Enter/Exit Programming Mode

Aiming Pointer

Enables/disables the aiming pointer for all symbologies.
$CTAAP01(CR)
Aiming Pointer = Enable

Aiming Duration Timer

Specifies the frame of time the aiming pointer remains on after decoding a label, when in trigger
single mode.The range for this setting is from 1 to 255 seconds in 1-second increments. See
page 280
DEFAULT
LSTM
Set Aiming Duration Timer
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again at
the beginning.
104
in "References" for a description of this feature.
$CTAAP00(CR)
Aiming Pointer = Disable
DEFAULT
LSTM00
Aiming Off After Decoding
To configure, scan the ENTER/EXIT PROGRAMMING
MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters
Appendix D, Keypad
in representing your desired
character(s). End by scanning the ENTER/EXIT bar code.
~
CANCEL
Gryphon™ I GD44XX/GBT4400/GM440X
Reading Parameters