Rf Features; Automatic Configuration Update; Rf Address Stamping - Datalogic Gryphon I GBT4400 Product Reference Manual

RF Features

Automatic Configuration Update

When this feature is enabled, the base station and reader will keep their configurations
synchronized. If a reader's configuration is altered by reading programming labels, this change is
automatically transferred and updated in a linked base station. Likewise, if the base station's
configuration is changed using Aladdin or by host commands, then the reader's configuration
will automatically be updated if this feature is enabled.

RF Address Stamping

Source Radio Address Delimiter Character
This option specifies the delimiter character to be placed between the label data and radio
address when address stamping is enabled.
Follow these instructions to select the delimiter character:
1. Determine the desired character, then find its hexadecimal equivalent on the
2. Go to
3. Scan the bar code: SET SOURCE RADIO ADDRESS DELIMITER CHARACTER.
4. Scan the appropriate two digits from the keypad in
5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit.
Table 46. Source Radio Address Delimiter Character Setting Examples
STEP ACTION
1 Desired Setting
2
3
Scan Two Characters From
4
Appendix D, Keypad
5
Product Reference Guide
This feature only applies if "Source Radio Address Transmission" on
page 243 is enabled.
on the inside back cover. A setting of 00 specifies no delimiter character.
page 244 and scan the ENTER/EXIT PROGRAMMING MODE bar code to
enter Programming Mode.
the hexadecimal characters which were determined in the steps above. You will hear a two-
beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
No delimiter
character
Scan ENTER/EXIT PROGRAMMING MODE
Scan SET SOURCE RADIO ADDRESS DELIMiTER CHARACTER
'0' and '0'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix D,
EXAMPLES
, (comma) - (dash)
'2' and 'C' '2' and 'D'

RF Features

ASCII Chart
Keypad, that represent
/ (slash)
'2' AND 'F'
285