General Specifications - Yamaha M7CL Owner's Manual

When you recall a scene, it takes a
certain amount of time for the faders to
stop
The panel LEDs or LCD display are too
dark / too bright
Signal level of a specific frequency is
low
Can't control an external head amp
(AD8HR)
Can't control the M7CL by M7CL
Editor.
In the LCD display, there are some
black points (unlit) or white points
(always lit).
Sampling Frequency
Signal Delay
Fader
Fader Resolution
Maximum Voltage Gain
Crosstalk (@1kHz)
Dimensions
Net Weight
Power Requirements
Operation free-air Temperature Range
Storage Temperature Range
Included Accessories
Optional Accessories
❍ Could you have specified a fade time? (→ p. 139)
❍ This can be adjusted in the SETUP screen. (→ p. 215)
❍ Could the EQ gain be turned down excessively?
❍ Routing a signal through a GEQ or effect will delay it relative to other signals. If this signal is mixed with
the signal via a different signal path, a comb filtering effect will cause the level of a specific frequency
to be decreased.
❍ Is the external head amp connected to the REMOTE connector?
❍ Is the audio output signal of the external head amp being input via an I/O card to SLOT 1–3?
❍ Is the input port of the external head amp set correctly?
❍ Could there be a problem with the cable that connects the M7CL and external head amp? Are you
using a D-sub 9-pin cross cable?
❍ Refer to M7CL Editor installation guide on our web site.
http://www.yamahaproaudio.com/
❍ Unfortunately, this is a common characteristic of TFT-LCDs and not a malfunction.
General Specifications
Internal: 44.1 kHz, 48 kHz
External: 44.1 kHz (-10%) to 48 kHz (+6%)
Less than 2.5 ms INPUT to OMNI OUT (@Fs = 48 kHz)
100mm motorized x62 (46)
+10 to -138, -∞ dB (1024 steps/100 mm)
86 dB INPUT1-48 to OMNI OUT
-80 dB Adjacent Input Channels (INPUT1-48, ST IN 1-4 [L, R], (GAIN:min) to OMNI OUT 1-16)
M7CL-48: 1274 x 286 x 701 mm (W x H x D)
M7CL-32: 1060 x 286 x 701 mm (W x H x D)
M7CL-48: 50 kg
M7CL-32: 42 kg
M7CL-48: 300 W, 110-240 V 50/60 Hz
M7CL-32: 250 W, 110-240 V 50/60 Hz
+10 °C to +35 °C
-20 °C to +60 °C
Owner's Manual
Dust cover
mini YGDAI cards
Gooseneck Lamp LA5000
Power Supply PW800W
Power Supply Link Cable PSL360
Troubleshooting • General Specifications
M7CL Owner's Manual
265