Specifications (Cs-R10, Cs-R10-S); General Specifications - Yamaha CS-R10 Systems Setup Manual

Specifications (CS-R10, CS-R10-S)

General Specifications

At the time of measurement, all faders are set to nominal. Output impedance of the signal generator is 150Ω.
Frequency response
Fs= 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz @20 Hz–20 kHz, reference to the nominal output level @1 kHz
Inputs
OMNI IN 1-8 OMNI OUT 1-8
Total harmonic distortion
Fs= 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz
Inputs
OMNI IN 1-8 OMNI OUT 1-8
OMNI IN 1-8 OMNI OUT 1-8
Internal OSC OMNI OUT 1-8
Internal OSC PHONES
* An 80kHz, 18 dB/octave low pass filter is used to measure total harmonic distortion.
*2
Hum & noise
Fs= 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz
Inputs
OMNI IN 1-8 OMNI OUT 1-8
OMNI IN 1-8 OMNI OUT 1-8
All Inputs OMNI OUT 1-8
— OMNI OUT 1-8
PHONES
—
*1. EIN stands for Equivalent Input Noise.
*2. An IHF-A filter is used to measure hum & noise level.
Dynamic range
Fs= 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz
Inputs
OMNI IN 1-8 OMNI OUT 1-8
— OMNI OUT 1-8
* An IHF-A filter is used to measure dynamic range.
46 RIVAGE PM10 System Setup Guide
Outputs RL
600Ω GAIN: +66 dB
Outputs RL
600Ω +4 dBu@20 Hz–20 kHz, GAIN: +66 dB
600Ω +4 dBu@20 Hz–20 kHz, GAIN: –6 dB
600Ω Full scale output @1 kHz
Full scale output @1 kHz,
8Ω
phones level control: max.
Outputs RL
Rs= 150Ω, GAIN: +66 dB
Master fader at nominal level and one
600Ω
Ch fader at nominal level.
Rs= 150Ω, GAIN: –6 dB
600Ω Master fader at nominal level and one
Ch fader at nominal level.
Rs= 150Ω, GAIN: –6 dB
600Ω Master fader at nominal level and all
OMNI IN1-8 in faders at nominal level.
600Ω Residual output noise, ST master off.
Residual output noise, phones level
8Ω
control min.
Outputs RL
600Ω AD + DA, GAIN: –6 dB
600Ω DA Converter
Conditions
Conditions
Conditions
Conditions
Min. Typ. Max.
–0.8 0.0 0.5
Min. Typ. Max.
0.12
0.05
0.02
0.2
Min. Typ. Max.
–128
*1
EIN
–62
–90 -85
-76
–92
–88
Min. Typ. Max.
114
116
Unit
dB
Unit
%
%
%
%
Unit
dBu
dBu
dBu
dBu
dBu
dBu
Unit
dB
dB