Analog Output Connections - Yamaha M7CL Owner's Manual

Connections

■ Analog output connections

PW800W power supply
Power cable
To the OMNI OUT jacks 1–16, you can patch the output signals from output channels (MIX, MATRIX, STEREO (L/R), MONO
(C)), monitor signals (MONITOR OUT L/R/C channel), and the direct out signals of INPUT channels 1–32 {1–48}.
When the M7CL is in the default state, the signals of the following channels are patched to each output port. (You are free
to change this patching as desired.)
OMNI OUT jacks 1–12
OMNI OUT jacks 13/14
OMNI OUT jacks 15/16
Below the M7CL's front pad there is a PHONES OUT jack for monitoring, and this jack always lets you monitor the signal
that is selected as the monitoring source (→ p. 141). By assigning the MONITOR OUT L/R/C channels to the desired out-
put jacks, you can monitor this same signal through external speakers (→ p. 142).
HINT
• If you connect the power cable to the AC IN jack and also connect the separately sold PW800W power supply, power
will continue to be supplied from the PW800W even if the internal power supply shuts down due to a problem.
40
M7CL Owner's Manual
Main speakers
MIX channels 1–12
MATRIX channels 1/2
STEREO channel (L/R)
Monitor speakers (foldback)
Monitor speakers