Yamaha M7CL Owner's Manual page 154

Operations in the METER screen
In the METER screen you can view the following
information for each channel.
1 Level meter
This is a realtime indication of the input (or output)
level of the corresponding channel.
∑
The segment will light if any of the level detection
points in each channel reach the OVER level.
∑
The segment level detection points are as follows.
• Input channels
........... PRE HPF, PRE FADER, POST ON
• Output channels
........... PRE EQ, PRE FADER, POST ON
HINT
∑
• If is lit, you can switch the metering point to determine the
point at which the overload is occurring.
B
Fader
This is a realtime indication of the top panel fader
position for the corresponding channel. The fader in
the screen cannot be operated.
C
Fader level
This indicates the current fader value in a range of
∞
- to 10.
154
M7CL Owner's Manual
2
If necessary, you can press a metering
point select button to switch the metering
point.
The metering point for the level meter can be specified
independently for input channels and output channels.
1
You can choose the following metering points.
● Input channels
• PRE HPF ........Immediately before the high-pass fil-
2
• PRE FADER ...Immediately before the fader
• POST ON........Immediately after the [ON] key
3
● Output channels
• PRE EQ ..........Immediately before the attenuator
• PRE FADER ...Immediately before the fader
• POST ON........Immediately after the [ON] key
HINT
• The metering point for output channels will also affect the
optional meter bridge (MBM7CL).
3
If you want the peak levels of the level
meter to be held, press the PEAK HOLD
button to turn it on.
PEAK HOLD button on/off operations will affect both
input channels and output channels as well as the
MBM7CL meter bridge. When you turn this button
off, the peak level indication that had been held will be
cleared.
HINT
• You can also assign the PEAK HOLD button on/off function to
a user-defined key ( → p. 200).
ter