Yamaha M7CL Owner's Manual page 49

Digital mixing console
Hide thumbs Also See for M7CL:
Table of Contents

Advertisement

3
In the Centralogic section, verify that the
[ON] of the corresponding input channel is
on.
4
In the STEREO/MONO MASTER section,
make sure that the [ON] key of the STEREO
channel is on, and raise the STEREO chan-
nel fader to 0 dB.
5
In the Centralogic section, raise the fader of
the corresponding input channel to an
appropriate volume.
In this state, you should now hear sound from the
speaker system that is patched to the STEREO chan-
nel.
HINT
• You can also adjust the input level using the faders of the
INPUT section or ST IN section instead of the faders of the
Centralogic section.
If you don't hear sound, check whether the LR meters
are moving in the METER field of the function access
area.
● If the LR meters are moving
It may be that the STEREO channel is not correctly
patched to the output jacks that are connected to
your speaker system. Check the output port patching
(→ p. 95).
● If the LR meters are not moving
It may be that the INPUT channel [ON] key is off.
Check the status of the [ON] key (→ p. 16).
HINT
• The signal being output from the STEREO channel can
also be monitored using headphones connected to the
PHONES OUT jack located below the front pad ( → p. 142).
6
To adjust the pan/balance of the signal sent
from each input channel to the STEREO
bus, press a knob in the TO STEREO/MONO
field of the screen to select it, and turn the
multifunction encoders of the Centralogic
section.
When you turn a multifunction encoder, the knob in
the TO STEREO/MONO field of the OVERVIEW
screen will also turn.
7
Use the navigation keys to switch the eight
channels controlled by the Centralogic sec-
tion, and make adjustments for other input
channels in the same way.
Setting up to use the M7CL
49
M7CL Owner's Manual
4

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

M&clM7cl-48M7cl-32

Table of Contents