Technical Specifications; General Specifications - Yamaha MG12XUK Owner's Manual

Technical Specifications

General Specifications

0 dBu = 0.775 Vrms, Output impedance of signal generator (Rs) = 150Ω
All level controls are nominal if not specified.
Frequency Response
Total harmonic distortion
(THD+N)
*1
Hum & Noise
(20 Hz to 20 kHz)
*2
Crosstalk (1 kHz)
Input channels
Output channels
Bus
Input Channel Function
Level Meter
Internal Digital Effect
USB Audio
Phantom Power Voltage
Power Supply adaptor
Power Consumption
Dimensions (W×H×D)
Net Weight
Included Accessory
Optional Accessory
Operating Temperature
*1 Noise is measured with A-weighting filter.
*2 Crosstalk is measured with 1 kHz band pass filter.
+0.5 dB/-1.0 dB (20 Hz to 48 kHz) ,
Input to STEREO OUT
refer to the nominal output level @ 1 kHz, GAIN knob: Min
0.02 %
Input to STEREO OUT
0.003 % @ +24dBu (1kHz), GAIN knob: Min
Equivalent Input Noise -128 dBu (Mono Input Channel, Rs: 150Ω, GAIN knob: Max)
Residual Output Noise -102 dBu (STEREO OUT, STEREO LEVEL knob: Min)
-83 dB
12 channels: Mono [MIC/LINE]: 6, Stereo[LINE]: 3
STEREO OUT: 2, PHONES: 1, MONITOR OUT: 1, FX SEND: 1
Stereo: 1, FX: 1
PAD CH 1 – CH 6
HPF CH 1 – CH 6
COMP CH 1 – CH 4
CH 1 – CH 6
EQ
CH 7/8 –
CH 11/12
PEAK LED CH 1 – CH 6
Post STEREO
2x7 -segment LED meter [PEAK, +10, +6, 0, -6, -10, -20 dB]
LEVEL knob
SPX Algorithm 24 programs, PARAMETER control:1, FOOT SW:1 (FX RTN CH on/off)
USB Audio Class 2.0 compliant
2 IN / 2 OUT
Sampling Frequency: Max 192 kHz, Bit Depth: 24-bit
+48 V
PA-10 (AC 38 VCT, 0.62A, Cable length = 3.6 m)
or equivalent recommended by Yamaha
22.9 W
315 mm × 91 mm × 297 mm (12.4" × 3.6" × 11.7")
3.0 kg (6.62 lbs)
Owner's Manual, AC Adaptor, Cubase AI Download Information
Foot Switch: FC5
0 to +40°C
@ +14dBu (20 Hz to 20kHz), GAIN knob: Min
26 dB
80 Hz, 12 dB/oct
1-knob compressor (Gain/Threshold/Ratio)
Threshold: +22 dBu to -8 dBu
Ratio:1:1 to 4:1,
Output level: 0 dB to 7 dB
Attack time: approx. 25 msec
Release time: approx. 300 msec
HIGH: Gain: +15 dB/-15 dB, Frequency: 10 kHz shelving
MID: Gain: +15 dB/-15 dB, Frequency: 2.5 kHz peaking
LOW: Gain: +15 dB/-15 dB, Frequency: 100 Hz shelving
HIGH: Gain: +15 dB/-15 dB, Frequency: 10 kHz shelving
LOW: Gain: +15 dB/-15 dB, Frequency: 100 Hz shelving
LED turns on when post EQ signal reaches 3 dB below clipping
21
MG12XUK Owner's Manual