Specifications; General Specifications - Yamaha RIVAGE PM7 Systems Setup Manual

Specifications

General Specifications

At the time of measurement, all faders are set to nominal. Output impedance of the signal generator is 150Ω.
Frequency response
Fs= 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz @20 Hz–20 kHz, reference to the nominal output level @1 kHz
Inputs
OMNI IN 1-8 OMNI OUT 1-8
Total harmonic distortion
Fs= 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz
Inputs
OMNI IN 1-8 OMNI OUT 1-8
OMNI IN 1-8 OMNI OUT 1-8
Internal OSC OMNI OUT 1-8
Internal OSC PHONES
* An 80kHz, 18 dB/octave low pass filter is used to measure total harmonic distortion.
*2
Hum & noise
Fs= 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz
Inputs
OMNI IN 1-8 OMNI OUT 1-8
OMNI IN 1-8 OMNI OUT 1-8
All Inputs OMNI OUT 1-8
— OMNI OUT 1-8
PHONES
—
*1. EIN stands for Equivalent Input Noise.
*2. An IHF-A filter is used to measure hum & noise level.
Dynamic range
Fs= 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz
Inputs
OMNI IN 1-8 OMNI OUT 1-8
— OMNI OUT 1-8
* An IHF-A filter is used to measure dynamic range.
48 RIVAGE PM7 System Setup Guide
Outputs RL
600Ω GAIN: +66 dB
Outputs RL
600Ω +4 dBu@20 Hz–20 kHz, GAIN: +66 dB
600Ω +4 dBu@20 Hz–20 kHz, GAIN: –6 dB
600Ω Full scale output @1 kHz
Full scale output @1 kHz,
8Ω
phones level control: max.
Outputs RL
Rs= 150Ω, GAIN: +66 dB
Master fader at nominal level and one
600Ω
Ch fader at nominal level.
Rs= 150Ω, GAIN: –6 dB
600Ω Master fader at nominal level and one
Ch fader at nominal level.
Rs= 150Ω, GAIN: –6 dB
600Ω Master fader at nominal level and all
OMNI IN1-8 in faders at nominal level.
600Ω Residual output noise, ST master off.
Residual output noise, phones level
8Ω
control min.
Outputs RL
600Ω AD + DA, GAIN: –6 dB
600Ω DA Converter
Conditions
Conditions
Conditions
Conditions
Min. Typ. Max.
–0.8 0.0 0.5
Min. Typ. Max.
0.12
0.05
0.02
0.2
Min. Typ. Max.
–128
*1
EIN
–62
–90 -85
-76
–92
–88
Min. Typ. Max.
114
116
Unit
dB
Unit
%
%
%
%
Unit
dBu
dBu
dBu
dBu
dBu
dBu
Unit
dB
dB