Yamaha M7CL Owner's Manual page 121

3
Use the buttons of the LINK PARAMETER
field to select the parameter(s) that will be
linked (multiple selections are allowed).
The table below lists the parameters you can select in
the LINK PARAMETER field.
HA button
EQ button
DYNAMICS 1, 2 button
MIX ON button
MIX SEND button
MATRIX ON button
MATRIX SEND button
FADER button
CH ON button
HINT
• If you link Dynamic 1 and 2 for two or more input channels,
the parameter values will be linked, but the key-in signals are
not linked. For more about dynamics, refer to "Using dynam-
ics" ( → p. 108).
• If you turn on the EQ button or DYNAMICS 1, 2 button, library
recall operations will also be linked.
4
If you turned on the MIX ON, MIX SEND,
MATRIX ON, or MATRIX send buttons in
step 3, use the buttons of the SEND
PARAMETER field to specify the bus(es) for
which you want operations to be linked
(multiple selections are allowed).
The table below lists the parameters you can select in
the SEND PARAMETER field.
MX 1–16 buttons
MT 1–8 buttons
NOTE
• If nothing is selected in the SEND PARAMETER field, send
on/off and send level will not be linked.
5
To link channels, hold down the [SEL] key
of the link-source input channel and press
the [SEL] key of the link-destination chan-
nel.
At this time, the values of the parameters you selected
in steps 3 and 4 will be copied from the link-source to
the link-destination channel. Subsequent operations of
the parameters you selected in steps 3 and 4 will be
linked between channels belonging to the same link
group.
The current link status is shown in the channel display
field of the window.
Head amp settings
EQ settings (including ATT/HPF)
Dynamics 1 and 2 settings
On/off status of signals sent to
MIX buses
Send levels of signals sent to
MIX buses
On/off status of signals sent to
MATRIX buses
Send levels of signals sent to
MATRIX buses
Fader operations
[ON] key operations
MIX buses 1–16
MATRIX buses 1–8
HINT
• If you want to link three or more channels, hold down the link-
source [SEL] key and successively press the [SEL] key of
each channel you want to add to the link group.
• When you press the [SEL] key of a channel belonging to a
link group to make it light, the [SEL] keys of all channels
belonging to the same link group will blink.
• If you link an INPUT channel to a ST IN channel, parameters
that do not exist for a ST IN channel will be ignored.
6
If you want to add a new channel to an
existing link group, hold down any [SEL]
key within the group and press the [SEL]
key that you want to add to the group.
HINT
• If the link-destination channel is already assigned to another
link group, its assignment to the previous group will be can-
celled, and it will be added to the newly assigned group.
7
To remove a channel from a link group, hold
down any [SEL] key in the same link group,
and press the [SEL] key of the channel that
you want to remove.
The Channel Link function
121
M7CL Owner's Manual
11