Yamaha M7CL Owner's Manual page 77

4
Use multifunction encoders 1–8 to adjust
the send level of the signals sent from up to
eight MIX channels or the STEREO/MONO
channels to the selected MATRIX bus.
If necessary, you can use the navigation keys and the
[SEL] keys of the Centralogic section to switch the
send-destination channel.
HINT
• If you want to monitor the signal being sent to a specific
MATRIX bus, use the navigation keys to access the corre-
sponding MATRIX channel in the Centralogic section, and
press the [CUE] key for that MATRIX channel.
5
If you want to make detailed settings for
MATRIX sends, press the TO MATRIX SEND
LEVEL knob inside the bold frame once
again.
When you press the currently selected TO MATRIX
SEND LEVEL knob once again, the MATRIX SEND
popup window will appear. The window includes the
following items.
3
4
5
6
1 SEND TO
This indicates the number, channel name, and icon of
the MATRIX bus that is currently selected as the send-
destination for signals.
B ← →
/ buttons
Use these buttons to switch between send-destination
MATRIX buses.
C
Channel select button
This indicates the channel number, the icon selected
for that channel, and the channel name. When you
press this button, that channel will be selected for
operations, and the corresponding [SEL] key will
light.
D
PRE button
This button selects the location from which the signal
of the MIX or STEREO/MONO channel will be sent
to the MATRIX bus. The signal is sent from the post-
fader position when this button is off, and from the
pre-fader position when this button is on.
E
TO MATRIX SEND ON/OFF button
This is an on/off switch for the signal sent from the
MIX or STEREO/MONO channel to the MATRIX
bus.
Sending signals from MIX channels and STEREO/MONO channels to MATRIX buses
1 2 7 8
F
TO MATRIX SEND LEVEL knob
This adjusts the send level of the signal sent from the
MIX or STEREO/MONO channel to the MATRIX
bus. To adjust the level, operate multifunction encod-
ers 1–8.
If the send-destination MATRIX bus is set to stereo,
the TO MATRIX PAN knob (for a stereo MIX channel
or the STEREO channel, the TO MATRIX BAL-
ANCE knob) and TO MATRIX SEND LEVEL knob
are shown in this location.
G
ALL PRE button
This button sets PRE as the position from which the
signal is sent from all channels to the MATRIX bus.
H
ALL POST button
This button sets POST as the position from which the
signal is sent from all channels to the MATRIX bus.
6
Use the TO MATRIX SEND ON/OFF buttons
to switch the signals sent from the MIX and
STEREO/MONO channels to the currently
selected MATRIX bus on/off.
7
If necessary, you can use the PRE button to
select the location from which the signal is
sent from each channel to the MATRIX bus.
8
Repeat steps 3–6 to adjust the send level
for other MATRIX buses in the same way.
77
M7CL Owner's Manual
6