Yamaha M7CL Owner's Manual page 152

Using the oscillator
4
Use the knobs and buttons in the parameter
field to adjust the oscillator parameters.
The displayed parameters will differ depending on the
oscillator selected in the MODE field. The knobs
shown in the parameter field can be operated using the
corresponding multifunction encoders.
The following table shows the available oscillator
types and the parameters displayed for each type.
Oscillator type
SINE WAVE 1CH
PINK NOISE
BURST NOISE
HINT
• The "LEVEL" parameter can also be adjusted using the
LEVEL knob in the MONITOR screen.
Details of each parameter are shown in the following
table.
Parameters
LEVEL
FREQ
HPF
LPF
WIDTH
INTERVAL
Level
INTERVAL
WIDTH
The BURST NOISE button is on
5
Press a button in the ASSIGN field to spec-
ify the bus(es) to which the oscillator signal
will be sent (multiple selections are
allowed).
These buttons correspond to the following buses.
MIX 1–16 buttons
MTRX 1–8 buttons
ST L, ST R buttons
MONO (C) button
HINT
• You can press the CLEAR ALL button to defeat all selections.
152
M7CL Owner's Manual
Parameters
LEVEL, FREQ
LEVEL, HPF, LPF
LEVEL, HPF, LPF, WIDTH, INTERVAL
Details
Oscillator output level
Frequency of the sine wave output from
the oscillator
High-pass filter (on/off switch, cutoff fre-
quency)
Low-pass filter (on/off switch, cutoff fre-
quency)
Length of noise
Length of silence between intervals of
noise
Pink noise output
MIX buses 1–16
MATRIX buses 1–8
STEREO bus L/R
MONO bus
6
To enable the oscillator, press the OUTPUT
button to turn it on.
The oscillator signal will be sent to the bus you
selected in step 5. When you press the button again,
the oscillator will turn off.
HINT
• You can also assign oscillator on/off or an ASSIGN change to
a user-defined key ( → p. 200).
Time