Yamaha M7CL Owner's Manual page 183

F CONTROL CHANGE field
Here you can make settings for control change trans-
mission/reception.
• Tx button....... Switches control change transmis-
sion on/off.
• Rx button ...... Switches control change reception
on/off.
• ECHO button
........... Selects whether incoming control
changes will be echoed out from the
MIDI transmit port.
G CONTROL CHANGE MODE field
Here you can select the control change transmission/
reception mode.
• NRPN button
........... If this button is on, the M7CL's mix
parameters will be transmitted/
received as NRPN messages on
one MIDI channel (NRPN mode).
• TABLE button
........... If this button is on, the M7CL's mix
parameters will be transmitted/
received as control change mes-
sages on one MIDI channel (TABLE
mode).
H PARAMETER CHANGE field
Here you can make settings for transmission/reception
of "parameter change" system exclusive messages.
• Tx button....... Switches parameter change trans-
mission on/off.
• Rx button ...... Switches parameter change recep-
tion on/off.
• ECHO button
........... Selects whether incoming parame-
ter changes will be echoed out from
the MIDI transmit port.
I OTHER COMMAND field
Here you can specify how MIDI messages other than
program changes, control changes, and parameter
changes (i.e., messages such as note-on/off and MIDI
timing clock) will be received.
• ECHO button
........... Selects whether other MIDI mes-
sages that are received will be ech-
oed out from the MIDI transmit port.
4
To specify the port that will be used to
transmit or receive each type of MIDI mes-
sage, press the transmit (Tx) or receive (Rx)
port select popup button.
The MIDI SETUP popup window for selecting the
port will appear. Operations in this window are the
same for both transmission (Tx) and reception (Rx),
and include the following items.
1
1 TERMINAL field
Select the port that will transmit or receive MIDI mes-
sages.
You can choose from the following items.
Item
NONE No port will be used.
MIDI Rear panel MIDI IN (Rx) / OUT (Tx) connector
REMOTE Rear panel REMOTE connector
A card that supports serial transmission, installed
SLOT 1–3
in a rear panel slot 1–3
B
PORT NO. field
If you select SLOT 1–3 in the TERMINAL field,
choose port number 1–8 in this field. (The number of
available ports will depend on the card that is
installed.)
The currently available card is valid only for port 1.
5
Specify the type of port and the port num-
ber.
↑ ↓
Use the / buttons to select an item. Press the OK
button to confirm the selected port and close the MIDI
SETUP popup window.
HINT
• Alternatively, you can select a port by pressing the desired
port name in the field, or by pressing the field to highlight it
and then turning one of the multifunction encoders to select
the port.
6
To specify the channel on which MIDI mes-
sages will be transmitted or received, press
the channel select popup button.
The MIDI SETUP popup window for selecting the
channel will appear. Operations in this window are the
same for both transmission (Tx) and reception (Rx),
and include the following items.
1
Basic MIDI settings
2
Explanation
183
M7CL Owner's Manual
17