Yamaha M7CL Owner's Manual page 263

Message
REMOTE: Data Overrun!
REMOTE: Rx Buffer Full!
REMOTE: Tx Buffer Full!
Saving Aborted.
SLOT x: Data Framing Error!
SLOT x: Data Overrun!
SLOT x: Rx Buffer Full!
SLOT x: Tx Buffer Full!
Storage Full!
Storage Not Found!
Storage Not Ready!
Sync Error! [xxx]
Tap Operation Ignored.
This Operation is Not Allowed.
Too Many Bands Used! Cannot Compare.
Too Many Bands Used! Cannot Paste to
Flex15GEQ.
Total Slot Power Capability Exceeded!
Unsupported File Format!
USB: Data Framing Error!
USB: Data Overrun!
USB: Rx Buffer Full!
USB: Tx Buffer Full!
Wrong Password!
Wrong Word Clock!
You Cannot Create User Key.
Invalid signals are being input to the REMOTE connector.
Too much data is being received at the REMOTE connector.
Too much data is being sent from the REMOTE connector.
Saving to the USB storage device has been interrupted.
Invalid signals are being input from the SLOT x input port.
Invalid signals are being input from the SLOT x input port.
Too much data is being received at the SLOT x input port.
Too much data is being sent from the SLOT x output port.
The file could not be saved because there is not enough space on the USB storage device.
The USB storage device could not be recognized.
Access is not possible because the USB storage device is not ready.
The M7CL is not synchronized with the [xxx] signal.
Tap operation was ignored because the TAP TEMPO button is not displayed in the screen.
This operation has been ignored because the current user does not have permission.
More than 15 bands are used, when trying to copy 31band GEQ and then compare with Flex15GEQ.
More than 15 bands are used, when trying to copy 31band GEQ and then paste to Flex15GEQ.
The I/O cards installed in the slots exceed the rated power capacity.
The file you attempted to load from the USB storage device is of an unsupported format.
Invalid signals are being input from the USB connector input port.
Invalid signals are being input from the USB connector input port.
Too much data is being received at the USB connector input port.
Too much data is being transmitted from the USB connector input port.
The password you input was incorrect.
The M7CL cannot synchronize because the source selected by MASTER CLOCK SELECT in the WORD
CLOCK screen is not appropriate.
The current user does not have permission to create a user key.
Warning/Error Messages
Meaning
M7CL Owner's Manual
263