Table of Contents
Advertisement
OPERATING INSTRUCTIONS
When leaving the premises, the system must be
Armed. However, before doing so, check that all
windows are closed and locked, all protected doors
are closed and PIR Detectors are not obstructed.
Ensure that pets are restricted to areas not protected
by PIR Detectors.
The system has 2 armed modes, Instant-Arm and
Delay-Arm.
Instant-Arm mode will immediately Arm the system.
Once the system is Armed, activating any detector, (i.e.
opening a door/windows protected by a Door / Window
Detector or moving into a PIR protected area), will
immediately trigger an Alarm. On returning to and
entering the property the system must be Disarmed
before opening any protected door or entering an area
protected by a PIR Detector otherwise an Alarm will
occur. For this reason when using Instant-Arm mode,
the system should be Armed and Disarmed from
outside the property using the Remote Control.
Delay-Arm mode will Arm the system with a
15 second entry/exit delay. On arming the system in
Delay-Mode the siren will beep once and then again
after the 15 second delay has expired. This allows
time for you to leave the property before the system
becomes fully Armed. On returning to and entering
the property by opening a protected door or moving
through a PIR protected area the system will be
triggered and the Siren will emit a single long beep.
However, an Alarm will not sound until the 15 second
delay has expired. The system must be Disarmed
using either the Remote Control or Keypad during the
15 second delay to prevent the Alarm from sounding.
If an Alarm occurs the Siren will sound continuously
until the set alarm duration time expires. The alarm
will then stop and the system will automatically
re-arm itself. This process can be repeated up to
3 times after which time the "Alarm Lockout" feature
will operate and prevent the system from re-arming.
Notes:
– To conserve power and maximise battery life the
PIR Detector will only detect movement if there
has been no movement detected within the
previous 2 minutes.
– The system can only be armed if the Siren is in
Operating Mode, (see page 19).
ARMING THE SYSTEM IN
INSTANT- ARM MODE
The system can be Armed in Instant mode by using
either the Remote Control or the Keypad as follows:
Remote Control:
Press the 'INSTANT-ARM' button,
Remote Keypad:
Enter your User Access Code followed by the
'INSTANT-ARM' button
?
?
?
User Access Code
The Siren will acknowledge the signal by beeping
once and flashing both indicator LEDs once.
ARMING THE SYSTEM IN
DELAY- ARM MODE
The system can be Armed in Delay mode using
either the Remote Control or the Keypad as follows:
Remote Control:
Press the 'DELAY-ARM' button,
Remote Keypad:
Enter your User Access Code followed by either
'DELAY-ARM' button.
?
?
?
User Access Code
The Siren will acknowledge the signal by beeping
once and flashing both indicator LEDs once. After
the fixed 15 seconds exit-delay has expired the siren
will produce a second single beep and flash both
LEDs again to indicate the system is fully armed.
The alarm cannot be triggered by activating and
PIR / MAG detector during the 15 seconds exit-delay.
If a PIR/MAG detector is triggered while the system
is armed in Delay-Arm mode the siren will produce
a single long beep and long flash of both LEDs.
However the alarm will not sound until the end of
the fixed 15 second entry-delay. If the system is
Disarmed before the entry-delay expires the alarm
will not sound.
,
?
,
or
?
1
2
21
Hide quick links:
Advertisement
Table of Contents
