Table of Contents
Advertisement
Operating Instructions
When leaving the premises, the system must be
rmed. However, before doing so, check that all
windows are closed and locked, all protected doors
are closed and PIR Detectors are not obstructed.
Ensure that pets are restricted to areas not
protected by PIR Detectors.
The system has 2 armed modes, Instant- rm and
Delay- rm.
Instant- rm mode will immediately
Once the system is
rmed, activating any detector
(i.e. Opening a door/windows protected by a
Magnetic Contact Detector or moving into a PIR
protected area), will immediately trigger an
On returning to and entering the property the system
must be Disarmed before opening any protected
door or entering an area protected by a PIR Detector
otherwise an larm will occur. For this reason when
using Instant- rm mode, the system should be
rmed and Disarmed from outside the property using
the Remote Control.
Delay- rm mode will
second entry/exit delay. On arming the system in
Delay-Mode the siren will beep once and then again
after the 15 second delay has expired. This allows
time for you to leave the property before the system
becomes fully rmed. On returning to and entering
the property by opening a protected door or moving
through a PIR protected area the system will be
triggered and the Siren will emit a single long beep.
However, an
larm will not sound until the 15
second delay has expired.
Disarmed using either the Remote Control or
Remote Keypad during the 15 second delay to
prevent the larm from sounding.
If an larm occurs the Siren will sound continuously
until the set alarm duration time expires. The alarm
will then stop and the system will automatically
re-arm itself. This process can be repeated up to
3 times after which time the ' larm Lockout' feature
will operate and prevent the system from re-arming.
Notes: To conserve power and maximise battery
life the PIR Detector will only detect movement if
there has been no movement detected within the
previous 2 minutes.
rm the system.
larm.
rm the system with a 15
The system must be
rming the System
RM
The system can be set in RM mode using either the
Remote Control or the Remote Keypad as follows:
Remote Control:
Press the
The Siren will acknowledge the signal by beeping
once.
Remote Keypad:
Press:
?
User Access Code
The Siren will acknowledge the signal by beeping
once.
DEL Y- RM
The system can be set in delay-arm mode using either
the Remote Control or the Remote Keypad as follows:
Remote Control:
Press the
The Siren will acknowledge the signal by beeping
once and then again after the 15 second entry/exit
period has expired. The system will not be fully
rmed and active until after the second beep.
Remote Keypad:
Press:
?
?
User Access Code
The Siren will acknowledge the signal by beeping
once and then again after the 15 second entry/exit
period has expired. The system will not be fully
rmed and active until after the second beep.
19
button.
?
?
?
,
button.
?
?
,
or
1
2
Hide quick links:
Advertisement
Table of Contents
