Table of Contents
Advertisement
SETTING UP AN AD HOC NETWORK
An ad hoc network is a temporary yet direct connection between a computer or device and the printer. It
does not connect through a router or base station and the data transfer rates are slower than the transfer
rate of standard wireless networks. The computer or device you wish to connect ad hoc to the printer must
have an ad hoc adapter installed. An ad hoc network is deleted when the user has disconnected from it or
is out of range of other devices on the network unless it has been made a permanent network.
1.
Select
SETUP
from the home screen.
2.
Using either the left or right the navigation arrows, navigate to the Network screen.
3.
Select WIFI.
4.
Select
ADHOC
from the Select WIFI Connection Type screen.
5.
Select the
ON/OFF
bar to turn on the ad hoc network connection.
6.
Confirm your choice by selecting the checkmark.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the CubePro 3D Printer and is the answer not in the manual?
Questions and answers