Connect To An Ad Hoc Network - 3D Systems cube User Manual

This printer is portable with a plug and print design that enables everybody in the family to express their creativity like never before

Hide thumbs Also See for cube:

Table of Contents

NOTE: If the printer could not connect to the network, you will be

directed to enter the passcode again .

NOTE: If the printer could not connect to the network, you will be

prompted to connect to a different network .

NOTE: The printer will indicate that it has successfully connected to

a network .

Connect To An Ad Hoc Network

NOTE: An ad hoc wireless connection cannot be created with Windows XP .

An ad hoc network is a temporary yet direct connection between a computer or device and the printer . It does not connect through a

router or base station and the data transfer rates are slower than the transfer rate of a standard wireless network . The computer or

device you wish to connect ad hoc to the printer must have an ad hoc adapter installed . An ad hoc network is deleted when the user

has disconnected from it or is out of range of other devices on the network unless it has been made a permanent network .

1 .

Select SETUP .

3D Systems, Inc.

Table of Contents