Kyocera ECOSYS M2030dn Operation Manual page 70

3
Enter the appropriate values to each field.
Setting
SMTP
SMTP Protocol
SMTP Server
Name
SMTP Port
Number
SMTP Server
Timeout
Authentication
Protocol
SMTP Security
POP before
SMTP Timeout
Connection Test
Domain
Restriction
POP3
POP3 Protocol
Check Interval
Run once now
Domain
Restriction
POP3 User
Settings
Set to send e-mail from the machine.
Set SMTP protocol. Set the "SMTP (E-mail TX)" setting to [On] on the
[Protocol Settings] page.
Enter the host name or IP address of the SMTP server.
Specify the port number to be used for SMTP. Use the SMTP default port
25.
Set the amount of time to wait before time-out in seconds.
Set whether SMTP authentication is used. To use authentication, enter the
user information for authentication.
Set SMTP security.
Turn on "SMTP Security" in "SMTP (E-mail TX)" on the [Protocol Settings]
page.
Specify the time in seconds until the connection to the POP server times
outs. This can be set when [POP before SMTP] is selected in
"Authentication Protocol".
Tests to confirm that the settings are correct.
Set whether or not domains are restricted. Click the [Domain List] and
enter the domain names of addresses to be allowed or rejected.
Restriction can also be specified by e-mail address.
Set to receive e-mail at the machine.
Set POP3 protocol. Set the "POP3 (E-mail RX)" setting to [On] on the
[Protocol Settings] page.
Specify the interval for checking for incoming e-mail in minutes.
Click [Receive] to connect to the POP3 server immediately and check for
incoming E-mails.
Set whether or not domains are restricted. Click the [Domain List] and
enter the domain names of addresses to be allowed or rejected.
Restriction can also be specified by e-mail address.
Configure the settings for POP3 user accounts and the POP3 server. You
can configure up to three users.
2-34
Preparation before Use
Description