Kyocera ECOSYS M2030dn Operation Manual page 367

LDAP Security
Select the communication protocol according to the type of security employed by the LDAP server. The default setting
is Off.
NOTE:
LDAP must be set to On in Protocol Detail on page 8-151.
The table below shows the available settings.
Item
Off
SSL/TLS
STARTTLS
* You can change the port number using Command Center RX.
Use the procedure below to make the setting.
Sys. Menu/Count.:a b
1
Report
2
Counter
3
*********************
System/Network
Login User Name:
*******************
Login Password:
System/Network:
1
*********************
Network Setting
2
I/F Block Set.
3
Security Level
Network Setting: a b
5
*********************
Secure Protocol
6
Host Name
7
LAN Interface
Do not use security employed by the LDAP server.
Encryption is applied any data communication. To enable LDAP security, the
LDAP port may have to be changed according to the server settings.
Typically, 636* for SSL/TLS is well-known LDAP port.
Encryption is applied any data communication. Typically, 389* for
STARTTLS is well-known LDAP port.
1
[ Exit ]
L b
[ Login ]
2
a b
[ Exit ]
3
4
[ Exit ]
8-159
Default Setting (System Menu)
Description
In the Sys. Menu/Count. menu, press the  or  key to
select [System/Network], and press the OK key.
A login screen will appear. Then, enter the user ID and
password with administrator privileges to log in, and
press [Login] (the Right Select key).
The System/Network menu appears.
Press the  or  key to select [Network Setting].
Press the OK key. The Network Setting menu appears.
8