Charging The Battery - Symbol SPT 1700 Series Product Reference Manual

Charging the Battery

Before using your SPT 1700 for the first time, charge the lithium-ion battery. The terminal's
battery can be charged using the Cradle, the Synchronization/Charging Cable, or the
Universal Battery Charger (UBC). For instructions on using the UBC to charge your batteries,
see the Quick Reference Guide which came with your UBC. Follow these same procedures to
recharge the battery when the terminal's battery level is low.
Using the Cradle to Charge the Battery
To charge the terminal's battery using the CRD 1700 cradle:
1. Make sure the battery is installed in the terminal. See Installing the Battery on page
1-12 for instructions.
2. Make sure the cradle is plugged into a wall outlet.
3. Insert the SPT 1700 terminal in the cradle as shown:
Battery
Charging
LED
On the CRD1700-1000S, the battery charging LED turns red to indicate that the battery is
charging, then turns green after approximately two hours to indicate that the terminal's
battery is fully charged.
Getting Started with the SPT 1700
1-13