Symbol SPT 1700 Series Product Reference Manual page 33

To set up for network communications:
1. Ensure there is a DHCP server accessible to the CRD1700-4000E on the subnet to
which it will be attached.
2. Connect one end of a standard 10 Base-T network cable to the middle connector on
the back of the CRD1700-4000E. Connect the other end of the cable to a hub which
is connected to your subnet.
3. Power-up the unit; the CRD1700-4000E performs its power-up sequence, then
attempts to collect all network parameters from the local DHCP server.
If configuration of the unit from the local DHCP server fails, all LEDs flash red. The unit
becomes unresponsive until power is removed, the unit is connected to a network with a
DHCP server, and power is restored.
Note: Before communication between the SPT 1700 terminal and the host
computer can take place, the Symbol Palm Terminal Desktop
Software must be installed and running on the host computer.
Getting Started with the SPT 1700
1-11