Symbol SPT 1700 Series Product Reference Manual page 32

SPT 1700 Series Product Reference Guide
the location of the serial port on your computer, refer to the user's
manual supplied with the computer.
See Chapter 9, Applications: HotSync® for instructions on configuring the cradle and
terminal for modem synchronization.
CRD1700-4000E Ethernet Cradle
Before setting up the cradle, make sure that Symbol Palm Terminal Desktop Software (p/n
SW-35138-xx) is installed and running on the host computer, as well as properly configured
Network HotSync software on the SPT 1700 terminal. See the section Symbol Palm Terminal
Desktop Software on page 1-21 for instructions on installing this software. Specific software
setup necessary to use the CRD1700-4000E is discussed in Chapter 9, Applications:
HotSync®.
A DHCP server must be configured and operational on the subnet to which the cradle will be
attached.
To connect the cradle:
1. Connect the power supply cable round plug to the power connector on the back of
the cradle.
2. Connect the power supply AC plug to a standard electrical outlet.
Note: International customers must use a separate AC power cable
appropriate for their respective country.
The cradle's LEDs blink, then remain off until a terminal is inserted into one or more of the
slots.
1-10
DC Power
Connector