Selecting The Another Monitor Item In The Selective Monitoring Mode - Mitsubishi Electric Freqrol-A100 Instruction Manual

3.1.2 Selecting the Another Monitor Item in the Selective Monitoring Mode
Selection procedure (Example: Select the input terminal state monitor screen.)
1) Press the [MONITOR]
......
Parameter unit is placed in the
key. monitoring mode.
4) Press the [READ] key.
....
The screen shown o n the right is
(Note 1) displayed.
I
4j
5 j
3) Hold down the [SHIFT] key and press the [ V ] key three
times, and without pressing the [SHIFT] key, press the [ V ]
key twice. (Move the cursor to signal In.)
Note: 1. Since the selective monitor screen is not the first priority screen in the above step 5) where
the [READ] key has been pressed, the selected data is erased from the memory as soon
as the power is shut off or the other operation mode (such as external operation) is
selected.
In this case, the selective monitoring mode must be selected again in the above
procedure.
When the first monitor screen has been set by pressing the [WRITE] key, the selected
data remains intact in the memory.
2. In step 5) where the [WRITE] key has been pressed in the above setting example, the "I10
terminal states" selected here are first displayed with priority when the other operation
mode is switched to the monitoring mode. To give first priority to other data, press the
[WRITE] key with the monitor screen being displayed. The first priority screen then
switches to that monitor screen.
......
Hold down the [SHIFT] key and press the [ V ] or
[ A ] key to advance or ret"rn the screen one page.
5) Press the [WRITE] key.
...
The screen in step 5) is set as
(Note 2)
the first priority screen.
......
Subsequently press the [SHIFT] key to call the
other monitor screen. (For monitor types, refer to
Pr. 52.)