2.1.3
Operation Mode
The inverter has three operation modes: "operation using the external input
signals" (external operation mode), "operation using the PU" (PU operation
mode), and "combined operation using the external input signals and PUN
(combined operation mode).
Factory-set operation mode
When the input power is switched on (or
the inverter is reset), the inverter is set
to the mode of "operation using the ex-
ternal input signals". Therefore, as soon
as the input power is switched on, the
inverter is ready for operation using the
external input signals. In this state, turn
the start signal (across STF, STR and
SD) on to start operation.
Started from the PU.
Direct setting of the frequency
Step setting of the frequency
Combined operation
H O I ~ down the FWD or REV
key to run the motor
Start signal is the external signal.
Frequency is set from the PU.
.
Started by the operation command
key of the PU.
frequency setting potentiometer.
Frequency is set from the external
' i
Fixing the operation mode
The operation mode at power on may
be limited, e.g. operation from the PU
is enabled at power on without switch-
ing the operation mode with the PU's
mode select key.
For full informationion the setting pro-
cedure, see page 34.