Removal
1) Remove the front cover installation screws.
Reinstallation
1) Fix the front cover with the installation screws.
Note: 1.
2.
Fully check that the front cover has been reinstalled securely.
The same serial number is printed on each of the capacity plate on the front cover and
the rating plate on the inverter side face. Before reinstalling the front cover, check the
serial number to ensure that the cover removed is reinstalled to the inverter from where
it had been removed.
Example:
Capacity plate A461 50
Rating plate
A46150
-
001
I
-
3-digit serial number
If the inverter surface is stained with fingermarks, oil and/or
the like during removal and/or reinstallation work, gently clean
it with a cloth soaked with a neutral detergent or ethanol.
-
-
-
Note: 1. Do not use any solvent, such as acetone, ben-
zene, toluene and alcohol, that will cause the in-
verter surface to dissolve and the paint to peel.
2.
Do not clean the lens of the inverter LED with a
detergent or alcohol.