Viewing Ip Connectivity; Table 3-36: Ip Connectivity Parameters - AudioCodes MP-124 User Manual

3.5.2.5

Viewing IP Connectivity

The 'IP Connectivity' page displays online, read-only network diagnostic connectivity
information on all destination IP addresses configured in the 'Tel to IP Routing' page (refer
to ''Configuring the Tel to IP Routing Table'' on page 131).
Notes:
To view the IP connectivity information:
1. In the 'Routing General Parameters' page, set the parameter 'Enable Alt Routing Tel to
IP' (or ini file parameter AltRoutingTel2IPEnable) to Enable [1] or Status Only [2].
2. Open the 'IP Connectivity' page (Status & Diagnostics tab > Gateway Statistics
menu > IP Connectivity page item).
Column Name
IP Address The IP address can be one of the following:
Host Name Host name (or IP address) as defined in the 'Tel to IP Routing' table .
Connectivity The method according to which the destination IP address is queried
Method periodically (ICMP ping or SIP OPTIONS request).
Connectivity The status of the IP address' connectivity according to the method in the
Status 'Connectivity Method' field.
SIP User's Manual
•
This information is available only if the parameter 'Enable Alt Routing Tel
to IP'/AltRoutingTel2IPMode (refer to ''Configuring Routing General
Parameters'' on page 130) is set to 1 (Enable) or 2 (Status Only).
•
The information in columns 'Quality Status' and 'Quality Info' (per IP
address) is reset if two minutes elapse without a call to that destination.
Figure 3-115: IP Connectivity Page

Table 3-36: IP Connectivity Parameters

IP address defined as the destination IP address in the 'Tel to IP Routing'
table.
IP address resolved from the host name defined as the destination IP
address in the 'Tel to IP Routing' table .
OK = Remote side responds to periodic connectivity queries.
Description
186
MP-11x & MP-124
Document #: LTRT-65412