AudioCodes MP-124 User Manual page 291

SIP User's Manual
Parameter
Enable FXS Caller ID Category
Digit For Brazil Telecom
[AddCPCPrefix2BrazilCallerID]
Version 5.8
[18] Standard India
[19] Standard Brazil
Notes:
Typically, the Caller ID signals are generated/detected
between the first and second rings. However, sometimes
the Caller ID is detected before the first ring signal (in such
a scenario, configure RingsBeforeCallerID to 0).
Caller ID detection for Britain [4] is not supported on the
device's FXO ports. Only FXS ports can generate the
Britain [4] Caller ID.
To select the Bellcore Caller ID sub standard, use the
parameter BellcoreCallerIDTypeOneSubStandard. To
select the ETSI Caller ID substandard, use the parameter
ETSICallerIDTypeOneSubStandard.
To select the Bellcore MWI sub standard, use the
parameter BellcoreVMWITypeOneStandard. To select the
ETSI MWI sub standard, use the parameter
ETSIVMWITypeOneStandard.
If you define Caller ID Type as NTT [2], you need to define
the NTT DID signaling form (FSK or DTMF) using
NTTDIDSignallingForm.
Enables the interworking of Calling Party Category (cpc) code
from SIP INVITE messages to FXS Caller ID first digit.
[0] Disable (default)
[1] Enable = Interworking of CPC is performed
When this parameter is enabled, the device sends the Caller ID
number (calling number) with the cpc code (received in the SIP
INVITE message) to the device's FXS port. The cpc code is
added as a prefix to the caller ID (after IP-to-Tel calling number
manipulation). For example, assuming that the incoming
INVITE contains the following From (or P-Asserted-Id) header:
From:<sip:+551137077801;cpc=payphone@10.20.7.35>;
tag=53700
The calling number manipulation removes "+55" (leaving 10
digits), and then adds the prefix 7, the cpc code for payphone
user. Therefore, the Caller ID number that is sent to the FXS
port, in this example is 71137077801.
If the incoming INVITE message doesn't contain the 'cpc'
parameter, nothing is added to the Caller ID number.
CPC Value in
Received INVITE
cpc=unknown
cpc=subscribe
cpc=ordinary
cpc=priority
291
6. Configuration Parameters Reference
Description
CPC Code
Prefixed to
Caller ID (Sent
to FXS
Endpoint)
1 Unknown user
1 -
1 Ordinary user
2 Pre-paid user
Description
September 2009