AudioCodes MP-124 User Manual page 297

SIP User's Manual
Parameter
Web/EMS: MWI Server Transport
Type
[MWIServerTransportType]
Web: MWI Subscribe Expiration
Time
EMS: MWI Expiration Time
[MWIExpirationTime]
Web: MWI Subscribe Retry Time
EMS: Subscribe Retry Time
[SubscribeRetryTime]
Subscription Mode
[SubscriptionMode]
[ETSIVMWITypeOneStandard]
[BellcoreVMWITypeOneStandard]
Version 5.8
Determines the transport layer used for outgoing SIP dialogs
initiated by the device to the MWI Server.
[-1] Not Configured (default)
[0] UDP
[1] TCP
[2] TLS
Note: When set to 'Not Configured', the value of the parameter
SIPTransportType is used.
The MWI subscription expiration time in seconds.
The default is 7200 seconds. The range is 10 to 72000.
Subscription retry time (in seconds) after last subscription
failure.
The default is 120 seconds. The range is 10 to 7200.
Determines the method the device uses to subscribe to an
MWI server.
[0] Per Endpoint = Each endpoint subscribes separately -
typically used for FXS interfaces (default).
[1] Per Gateway = Single subscription for the entire device -
typically used for FXO interfaces.
Selects the ETSI Visual Message Waiting Indication (VMWI)
Type 1 sub-standard.
[0] = ETSI VMWI between rings (default)
[1] = ETSI VMWI before ring DT_AS
[2] = ETSI VMWI before ring RP_AS
[3] = ETSI VMWI before ring LR_DT_AS
[4] = ETSI VMWI not ring related DT_AS
[5] = ETSI VMWI not ring related RP_AS
[6] = ETSI VMWI not ring related LR_DT_AS
Note: For this parameter to take effect, a device reset is
required.
Selects the Bellcore VMWI sub-standard.
[0] = Between rings (default).
[1] = Not ring related.
Note: For this parameter to take effect, a device reset is
required.
297
6. Configuration Parameters Reference
Description
September 2009