AudioCodes MP-124 User Manual page 329

SIP User's Manual
Parameter
Hunt Group Settings Table
[TrunkGroupSettings]
Web: Channel Select Mode
EMS: Channel Selection Mode
[ChannelSelectMode]
Version 5.8
For a description of ini file table parameters, refer to ''Format
of ini File Table Parameters'' on page 191.
This ini file table parameter defines rules for port allocation per
Hunt Group. If no rule exists, the global rule defined by the
parameter ChannelSelectMode takes effect. The format of this
parameter is as follows:
[TrunkGroupSettings]
FORMAT TrunkGroupSettings_Index =
TrunkGroupSettings_TrunkGroupId,
TrunkGroupSettings_ChannelSelectMode,
TrunkGroupSettings_RegistrationMode,
TrunkGroupSettings_GatewayName,TrunkGroupSettings_Cont
actUser, TrunkGroupSettings_ServingIPGroup;
[\TrunkGroupSettings]
For example:
[TrunkGroupSettings]
TrunkGroupSettings 0 = 1, 0, 5, audiocodes, user, 1;
TrunkGroupSettings 1 = 2, 1, 0, localname, user1, 2;
[\TrunkGroupSettings]
Notes:
This parameter can include up to 24 indices.
For configuring Hunt Group Settings using the Web interface,
refer to ''Configuring Trunk Group Settings'' on page 150.
For a description on using ini file table parameters, refer to
''Format of ini File Table Parameters'' on page 191.
Port (channel) allocation algorithm for IP-to-Tel calls.
[0] By Dest Phone Number = Selects the device's channel
according to the called number (defined in the 'Endpoint
Phone Number' table -- Configuring the Endpoint Phone
Numbers on page 149). (default.)
[1] Cyclic Ascending = Selects the next available channel in
an ascending cyclic order. Always selects the next higher
channel number in the hunt group. When the device reaches
the highest channel number in the hunt group, it selects the
lowest channel number in the hunt group and then starts
ascending again.
[2] Ascending = Selects the lowest available channel. It
always starts at the lowest channel number in the hunt group
and if that channel is not available, selects the next higher
channel.
[3] Cyclic Descending = Selects the next available channel in
descending cyclic order. Always selects the next lower
channel number in the hunt group. When the device reaches
the lowest channel number in the hunt group, it selects the
highest channel number in the hunt group and then starts
descending again.
[4] Descending = Selects the highest available channel.
Always starts at the highest channel number in the hunt
group and if that channel is not available, selects the next
329
6. Configuration Parameters Reference
Description
September 2009